Communication Within The Computer System

Submitted By Ashutosh-Das
Words: 8319
Pages: 34
Open Document
Table of Contents
INTRODUCTION 4
Activity 1 4
COMMUNICATION CONCEPTS 6
Serial and parallel transmission 6
Activity 2 6
Simplex, Half Duplex and Full Duplex Transmission 7
Activity 3 7
Synchronous and Asynchronous Transmission 8
Activity 4 8
MEASUREMENTS OF SPEED 9
Activity 5 9
Comparison of Data Transfer Speeds for Text 10
Activity 6 10
Calculating Speed 11
Activity 7 11
Activity 8 12
HARDWARE IN TRANSMITTING AND RECEIVING 14
Communication Within the Computer (the System or Internal Bus) 14
Activity 9 14
Communication with External Devices (External Buses) 15
Activity 10 15
Activity 11 16
Activity 12 17
The Role of Modems 18
Activity 13 18
Activity 14 19
Local Area Networks (LANs) 20
Activity 15 20
Wide Area Networks (WANs) 23
Activity 15 23
SOFTWARE FOR TRANSMITTING AND RECEIVING 24
Software that Interfaces with Hardware 24
Activity 16 24
Software for Transferring Text, Numeric, Image, Audio and Video 25
Activity 17 25
NON-COMPUTER TOOLS FOR TRANSMITTING AND RECEIVING 26
Activity 18 27
SOCIAL AND ETHICAL ISSUES ASSOCIATED WITH TRANSMITTING AND RECEIVING 28
Quality of Information Received from the Internet 28
Activity 19 28
Security of Data Being Transferred 30
Activity 20 30
Net-Etiquette 32
Activity 21 32
Global Issues – Time Zones, Date Fields, Exchange Rates, Foreign Languages 33
Activity 22 33
Changing Nature of Work for Participants – Working from Home or Telecommuting 34
Activity 23 34
Current and Future trends in Digital Communication 41
Activity 24 41

INTRODUCTION

The transmitting and receiving information process transfers information and data within and between information systems. This transfer of data occurs between components within a single computer, such as the transfer of data between RAM and the CPU. It occurs whenever peripheral devices are used, such as keyboards, printers and modems. It also occurs between computers when communicating using local area networks and wide area networks such as the Internet.
Activity 1

Complete the following:

Transmitting and receiving is the process that transfers information / data within and between hardware. Within a computer system, data is transmitted and received among the various parts of the system. This makes maximum use of transmission speeds because the data is in digital form. Digital signals use on off electrical pulses, and this kind of signal works well in representing two-state binary code, the 0s and 1s used by computers.

In order to transmit and receive between computer systems, it is necessary to have a link between the computers. Such a link creates what is referred to as a transmission. Not all the connections on a network are continuous. Many of our traditional means of transmitting data electronically are analog. Analog data is represented as a continuous wave rather than the discrete signals used for digital transmission. This results in a need to convert signals from one form to another when using certain types of hardware. This, and the type of link used, will affect the speed of transmission.

Transmitting and receiving can be carried out in many different ways: computer networks, analog phone networks, mobile digital phone networks, papers, facsimiles, the internet and a range of traditional method from signals to letter and parcel mail.

Word list binary code, continuous, digital, hardware, maximum, network, on and off, speed, system, transfers, transmission

COMMUNICATION CONCEPTS
Serial and parallel transmission

Data can be sent as serial or parallel transmission. Both types are used in sending and receiving data. Complete the table comparing the two types of transmission.
Activity 2

Type
Description
Diagram / Picture
Advantages and Disadvantages
Examples of use
Serial transmission
Data bits flow along a single connecting link or wire one after the other. To send one byte of data each of the eight bits is sent separately one after the other.

Can travel long distances using only 2 wires
Show More

Related Documents: Communication Within The Computer System

Electromagnetic Radiation and Electron Essay

7) The electron in the receiving antenna oscillates at a lower frequency than the electron in the transmitting antenna because of the distance between the antennas. False. When the electron in the transmitting antenna oscillates, it sets up an electromagnetic wave oscillating at the same frequency. This electromagnetic wave in turn causes the electron in the receiving antenna to oscillate at the same frequency. So the electrons in the transmitting and receiving antennas must oscillate at the…

Words 1148 - Pages 5

Optical Fiber and Field Diameter Mismatch Essay

Splicing and Connection Performance Three factors that could affect splice performance can be caused by attenuation, modal dispersion, and chromatic dispersion. Attenuation can cause performance issues because of dirty fiber end faces, excessive gaps between fibers or improperly installed connector offsets of fiber cores when mated. Another factor that can affect performance connections is angle acceptance also known as modal dispersion. This has to do with a differential delay between the…

Words 447 - Pages 2

Essay on Communication and Radio

North can you please send your message again, over” Radio Check Procedure When requesting a radio check you are to use the following procedure: Site Staff:” Zero Zero this is Tango 1 North radio Check, over” Control: “Tango 1 North this is Zero, receiving you loud and clear, over” Site Staff: “Zero this Tango 1 North Message Received, Out” Use of names over the radio When communicating over the radio regarding a visitor or site staff where you have to use their name you follow the following…

Words 714 - Pages 3

Essay about P6 1

infrared light spectrum to send a focused light beam to a receiver (the data), much, as would a microwave system, although no reflective dish is used. Rather, a pair of lenses is used, with a focused lens employed in the transmitting device and a collective lens in the receiving device. Infrared is an airwave, rather than a conducted transmission system. Additionally, infrared offers substantial bandwidth at relatively low Cost. However, infrared systems require line-or-sight and suffer from environmental…

Words 595 - Pages 3

Radio and Tc- 446 s Essay

ICNIRP exposure limits for occupational/controlled RF exposure environment at operating duty factors of up to 50% transmitting and is authorized by the FCC for occupational use only. In terms of measuring RF energy for compliance with the FCC exposure guidelines, your product radiates measurable RF energy only while it is transmitting (during talking), not when it is receiving (listening) or in standby mode. Your product complies with the following of RF energy exposure standards and guidelines…

Words 3515 - Pages 15

Demonstrative Communication PaperAmontchi SylvainBCOM214November 11 2014Gioconda

Communication Paper Amontchi Sylvain BCOM/214 November 11, 2014 Gioconda Rodriguez-Padilla Demonstrative Communication Communication can hold one of many definitions. As our text says, “communication is the process of transmitting, conveying or sending and accepting or receiving messages.” (Cheesbro, O’Connor, and Rios, 2010). Communication consists of the exchange of data, ideas, instructions, and messages via speech, writing, kinesics, body language, and/or behavior. Such information can be exchanged…

Words 1312 - Pages 6

Notes On Communication Systems

Retransmit data * Character substituting. | Application level | HTTP: * Hypertext transfer protocol * Protocol in web browsers to communicate and receive web pages SMTP: * Simple mail transfer protocol * Used to allow sending and receiving of email addresses using internet SSL: * Secured socket layer * Provides security when transferring data over the internet * Encrypts data into a code. | Communication control and addressing level | TCP * Transmission control…

Words 1432 - Pages 6

Data Transmission Essay

connected on the same circuit. This means that each must share the circuit with the others, much like a party line in telephone communication. The disadvantage is that only one computer can use the circuit at a time. When computer is sending or receiving data, all others must wait. The advantage of multipoint circuits is that they reduce the amount of cable required and typically use the available communication circuit more efficiently. Multipoint configurations are cheaper than point-to-point configurations…

Words 1500 - Pages 6

Communication Lecture Essay

Slide 1 - Communication We are going to start today by discussing the importance of communication in leadership and examine the communication process of sending and receiving messages. So we first begin with the definition of communication, in that it is the process of conveying information and meaning. However, true communication will only take place when all parties understand the message from the same perspective. So basically the message needs to be clear and understandable. Achieving…

Words 544 - Pages 3

Essay on Remote Control and Control Signal

BACKGROUND OF THE INVENTION A typical remote control system for controlling the operation of electrical apparatus has two parts. The first partis a receiver provided at the apparatusunder control, and the second part is a transmitter for generating and transmitting a control signal for receipt by the receiver to control the apparatus. The transmitter invariably includes keys, buttons and/or switches for operation, which increasethe production cost of the overall transmitter and their design cannot be changed…

Words 2880 - Pages 12